We have a unique situation where our transport equipment can't bridge the traffic between two endpoints, so we would like to dump off each link's VLAN onto our router (7609-S with WS-X6748-GE-TX blades) where it can perform the bridging. Any reason why the following configuration wouldn't work?
interface GigabitEthernet1/31 description Customer networks switchport switchport trunk encapsulation dot1q switchport trunk allowed vlan 221-222 switchport mode trunk end interface Vlan221 description Site 1 no ip address bridge-group 2 bridge-group 2 spanning-disabled ! interface Vlan222 description Site 2 no ip address bridge-group 2 bridge-group 2 spanning-disabled ! Some of you might ask why not put the endpoints in the same VLAN, but the endpoints don't maintain an MAC address table so there's nothing to make them exchange traffic with each other. Regards, Frank _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/