Drew,

Did you look at spanning-tree and confirm that the vlan was no longer in 
spanning-tree? The switch will not turn the vlan interface down if the vlan is 
still in use in spanning-tree.

--
Regards,

Jason Plank
CCIE #16560
e: [EMAIL PROTECTED]

 -------------- Original message ----------------------
From: Drew Weaver <[EMAIL PROTECTED]>
>                 Hi there. We have seen this issue on two separate Catalyst 
> 6500s 
> in the past two weeks or so, we've noticed that on occasion either with a 
> Layer 
> 3 VLAN with no FastEthernet/GigabitEthernet port attached to it, or with one 
> attached to it which is either down or administratively shutdown that the 
> Layer 
> 3 VLAN refuses to notice that it should in fact "give it a rest" as they say. 
> Has anyone seen anything similar to this in the past. We aren't running VTP 
> or 
> any multi-switch/campus wide VLANs. All of our VLANs are contained 
> intra-switch. 
> Both switches are running the same version of code. The only remedy we've 
> found 
> for solving this issue is to simply blow away the VLAN (which is usually what 
> we're trying to do when we notice this anyway), but we are a little concerned 
> by 
> what could be the cause.
> 
> Thanks.
> -Drew
> 
> _______________________________________________
> cisco-nsp mailing list  [email protected]
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/

_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

Reply via email to