> Date: Sun, 4 May 2008 00:36:01 -0500 > From: "Dan Letkeman" <[EMAIL PROTECTED]> > Subject: [c-nsp] 2801 - can it handle this? > To: cisco-nsp@puck.nether.net > Message-ID: > <[EMAIL PROTECTED]> > Content-Type: text/plain; charset=ISO-8859-1 > > Hello, > > I have a 2801 router with the firewall IOS. I have a 10mbit > connection to the internet. There will be anywhere from 100-300 users > using this router for browsing the internet at one time. > > I will be running ips and some security acl's. No voip, maybe one or > two video connections. > > Will this router be able to handle this amount of connections? > > Thanks, > Dan. >
The specs from Cisco say no problem, but I've run into a number of issues trying to use ISRs (2800 and 1800 series) for multiple purposes simultaneously (router, firewall, etc). The closest case I had to your scenario was trying to use 2 2811s as a failover/redundant firewall with NAT and IPS. We hardly had traffic reaching 10Mb, but the setup kept crashing - the reason was never fully tracked down, TAC was taking too long. Replaced with a pair of ASAs, not a single hiccup since. Similar experiences elsewhere - I don't see these platforms as viable for firewall/IPS purposes unless the traffic levels are very low. I don't know if this is due to bugs or performance limitations. For similar money, the PIX or ASA appliances are far more stable and can handle much higher loads. Michael _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/