If the route is in BGP already, then answer to both of your questions is no. You will need it only on a router that is "injecting" it into the BGP from some other protocol. You will also need it on a router that has a full routing table, but for some reason you wish it to advertise subset+default to neighbors.
On Thu, Jul 3, 2008 at 08:34, Michael Robson <[EMAIL PROTECTED]> wrote: > I used to think that I had a handle on when the default information > originate command was needed, but I have recently seen working config. that > pokes a finger in my eye of understanding, where some bad Ciscco document > caused further blurring; and so some questions > > - Should the default-information originate command be needed within BGP > configuration of a router to cause a default route that has been learnt from > an eBGP peer to be advertised by this router to its iBGP peers? > > - Similarly, should this command be needed to cause a default route that has > been learnt from an iBGP peer to be advertised by the router to an eBGP > peer? > > Ta. > > Michael. _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/