Hi again, It may be a bit unclear, but on the 3560/3750-platform, you'll have to do egress policing by manipulating the DSCP-values on input-interfaces and tweaking the srr-queues on the output-interfaces.
The old 3550-platform supported egress policing via aggregate-policers, a bit more logically and without the need for changing any values. Best regards, Stig Meireles Johansen -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Kurt Bales Sent: 15. juli 2008 13:57 To: cisco-nsp@puck.nether.net Subject: [c-nsp] Shape an L3 interface to 100mbit Hey Guys, I have a situation where my upstream is policing my connection to 100mb. I have a GigE interconnect to them, and we are currently connected at 1gb/full duplex. I have been requested to shape the traffic leaving our interconnect to 100mb so as to reduce the performance issues caused by packet loss etc caused by policing. What is the easiest way to apply 100mb shaping to an L3 (no switchport) interface on a 3560G? The speed of this link could change in the near future (over the next couple of days) so I would prefer to use QoS rules to apply shaping to this interface as opposed to forcing the interconnect to 100/Full (which would be of no use if the link changed to 250mb). Regards, K. _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/