Hi Guys,
> In general, you enable "mls qos vlan-based" on the trunk, and apply
the
> qos policy on the SVI (interface vlan) - even without any L3 config on
> the SVI.
>
For Qos this works very well. I have an aditionall requirement.
Now I have to change the Cos values on the trunk Port.
So there is trunk between an Cisco Catalyst 4500 and a Juniper ERX.
I want to change the CoS Values for every Vlan in a different way.
For Example: VLAN 15 CoS =5
VLAN 10 CoS =3
VLAN 20 CoS =1
My idea was to enhance the current policy-map configuration with
the command "set cos x", but unfortunately the switch doesn't accept
this
command, although it is documented in CCO. I checked the Feature
Navigator and
IOS 12.2(40)SG IPBASE has the feature "Class Based Ethernet CoS Matching
& Marking (802.1p & ISL CoS)".
So any ideas, why I can not configure this on my cat4500 ?
Is there another way to achieve this ?
Regards,
Ahmad
Sitz der NK Networks & Services GmbH: Von-der-Wettern-Straße 15, 51149 Köln
Registergericht: Amtsgericht Köln, Registernummer HRB 30805
Geschäftsführer: Tonis Rüsche
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
