Huh?
FA0/0 connects directly to the TLS and FA0/1 connects to the customer
switch. The TLS passes through the router before it ever hits their
public switch.
[EMAIL PROTECTED] wrote:
Servers
|
7206VXR ---------TLS-------- 2651XM ------- Public switch -------
Firewall ------- LAN
CPE config:
interface FastEthernet0/0
desc TLS side
no ip address
speed 100
full-duplex
!
interface FastEthernet0/0.xxx
encapsulation dot1Q xxx
ip address 192.168.1.2 255.255.255.252
(rate limit to 10M)
no cdp enable
[snip]
ip route 0.0.0.0 0.0.0.0 192.168.1.1
Your diagram and config conflict with each other; according to the config,
you're routing to the TLS *through* the switch. According to the diagram, the
2651XM is directly connected to the TLS, and is directly connected to the
switch.
My guess is that the switch leaks traffic between VLANs. The easiest workaround
is probably just to connect the 2651XM directly to the TLS. They didn't have
the problem with the T1s since they weren't going through the switch.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
