Got it Cheers
Mark ----- Original Message ---- From: Oliver Boehmer (oboehmer) <[EMAIL PROTECTED]> To: Mark Tech <[EMAIL PROTECTED]> Cc: cisco-nsp@puck.nether.net Sent: Wednesday, November 26, 2008 3:17:10 PM Subject: RE: [c-nsp] Static default route VRF not appearing Mark Tech <> wrote on Wednesday, November 26, 2008 15:44: > Hi > In an IP-VPN test, I need to add a static default route pointing to > CE1 from PE1. This would I assume be redistributed to other PE's, > then CE routers as 'redistribute static' is enabled on the PE config > for this customer however this seems not to be the case. > > In fact PE2 never even sees that particular static route, even though > it can see other redistributed static routes that I put in just to > check. Is there some extra config needed on PE1 in order for the 0/0 > static route to be advertised to other PE's and therefore CE's such > as default-originate as per standard BGP? yes, you need the same commands in ipv4 vrf as in "standard BGP", i.e. default-information originate in this case. oli _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/