I figured it out.. example: access-list inside_nat0_outbound permit ip 192.168.1.0 255.255.252.0 172.16.4.0 255.255.252.0 nat (inside) 0 access-list inside_nat0_outbound
Scott Ingram Manager, IT Operations Clayton 2 Corporate Drive Shelton, CT 06484 work: 203.926.8148 cell: 203.258.2037 [email protected] <mailto:[email protected]> www.clayton.com <http://www.clayton.com/> ________________________________ From: Mario Spinthiras [mailto:[email protected]] Sent: Fri 12/12/2008 4:36 PM To: Scott Ingram Cc: [email protected] Subject: Re: [c-nsp] ASA 5520 inside interface used for Clients Default Gateway If you have a default rule for NAT then have you tried adding an exemption in the NAT list for th eparticular network? Can you give me more of an insight on the network , addressing , interfaces , routes and security rules? Regards, Mario A. Spinthiras http://www.spinthiras.net/ IMPORTANT NOTICE: This message is intended only for the use of the individual or entity to which it is addressed and may contain information that is privileged, confidential and exempt from disclosure under applicable law. If you have received this message in error, you are hereby notified that we do not consent to any reading, dissemination, distribution or copying of this message. If you have received this communication in error, please notify the sender immediately and destroy the transmitted information. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
