On Mon, Mar 16, 2009 at 07:40:30PM +0000, Jimmy Changa wrote:
I have a 6500 with a sup720-3BXL. Every time I put a WS-X6408A-GBIC card in
the chassis, diag fails the card.
I haven't rebooted the box yet, as this carrys a significant amount of
traffic, has anyone else seen this type of problem.
Diag on the most recent card shows:
7) TestUnusedPortLoopback:
Port 1 2 3 4 5 6 7 8
----------------------------
U U U F U U U F
Some of the diags are heavily dependent on IOS config, usually only the
disruptive ones though. I don't have any 6408s but what does:
sh diagnostic content module X
....say when the card is inserted? It should list some details about
test #7 i.e. whether it's a bootup/health test, which I'd expect to pass
in all circumstances.
A few weeks ago, I'd have said you may have a bad slot, but recently we
had a slot "go funny" and no amount of fiddling would clear it *except*
a reload of the box, so it's definitely worth trying.
The cards work in other chassis.
Have you tried other cards in that slot?
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
