Yup, that was the ticket. Thanks Tim! -graham
On 7/31/09 11:06 AM, "Tim Stevenson" <[email protected]> wrote: > Hi Graham, > > You need to do this from *both* rommons. The config reg is sync'd between RP & > SP when you do a write mem, but if you are manually changing it from in the > rommon, then each rommon is going to have an independent value. > > Break to the SP, confreg 0x2142, reset, then wait for the RP rommon to take > control, it's after this msg: > 00:00:07: %OIR-SP-6-CONSOLE: Changing console ownership to route processor > > Then break to RP, confreg 0x2142, and reset, the box should come up w/no > running config (startup will still have everything). > > Make sure to restore the config-register 0x2102 in config mode & write mem > after you've changed the password. > > Hope that helps, > Tim > > > > At 06:35 AM 7/31/2009, Graham Wooden asserted: > >> Thanks Tim and Jesse for the replies. >> >> Well, I only had a small window this morning to get this resolved and >> both confregs from rommon didn't seem to bypass the config like I >> wanted. Also tried just confreg with no args, and selecting it to >> ignore the config with still no affect. >> >> But as I type this, I did it from the SP rommon. Should I have done >> the break at the RP boot instead? >> >> I will have another window this evening to get this resolved. Thanks >> for any suggestions. >> >> -graham >> >> >> Quoting Tim Stevenson <[email protected]>: >> >>> > Hi Graham - >>> > >>> > The same rules for confreg that apply to the other c6k sups apply here >>> > as well. >>> > >>> > Typical/recommended for sup32 is 0x2102. To ignore config 0x2142 will >>> > do it. 0x42 should work too, but for one thing, ignore break will be >>> > disabled, which is not desirable (router can drop to rommon during >>> > runtime due to deliberate/spurious break). >>> > >>> > Hope that helps, >>> > Tim >>> > >>> > >>> > >>> > At 06:07 PM 7/30/2009, Graham Wooden asserted: >>> > >>>> >> Hi there, >>>> >> >>>> >> Not much out there on this for the Sup32. But since the Sup32 is a >>>> upgraded >>>> >> MSFC2, will the config register ³0x42² bypass the config? >>>> >> Someone borked up the aaa auth and I can't get into it. Bah. >>>> >> >>>> >> Thanks, >>>> >> >>>> >> -graham >> > > > > > Tim Stevenson, [email protected] > Routing & Switching CCIE #5561 > Technical Marketing Engineer, Cisco Nexus 7000 > Cisco - http://www.cisco.com > <http://www.cisco.com/> IP Phone: 408-526-6759 > ******************************************************** > The contents of this message may be *Cisco Confidential* > and are intended for the specified recipients only. > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
