Hello group, I have a ES20 interface configured with L2 services via the "service instance" command. Now i would like to add L3 services to the same physical interface but i noticed a problem with IPv6:
7600# 7600#conf t Enter configuration commands, one per line. End with CNTL/Z. 7600(config)#! 7600(config)#interface GigabitEthernet3/0/0.200100 7600(config-subif)# encapsulation dot1Q 200 second-dot1q 100 7600(config-subif)# ip address 20.20.20.254 255.255.255.0 7600(config-subif)# ipv6 address 2001:20::2/64 ^ % Invalid input detected at '^' marker. 7600(config-subif)#ipv6 ? % Unrecognized command 7600(config-subif)# After removing all the service instance entries, the IPv6 command was accepted. Is this a known limitation ? I saw the same problem with 12.2(33)SRC2 and 122-33.SRD2a. Thanks. Regards, Antonio Soares, CCIE #18473 (R&S) amsoa...@netcabo.pt _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/