On Mon, Nov 23, 2009 at 09:10:25AM +0100, Gert Doering wrote: > "bgp update-delay <n>" > > "the bgp update-delay command is used to tune the maximum time the > software will wait after the first neighbor is established until it > starts calculating best paths and sending out advertisements". > > Now, what does "maximum time" mean? Will it wait, or will it not? > > The documentation that I found claims that the default value is "120", > which would certainly not agree with the observed behaviour. OTOH, > Marco claims that he has seen "0" as a default...
The docs make it look like more of a graceful-restart specific timer, not like advertisement-interval (intentionally delaying the propagation of new updates to try and consolidate them) or the "on-startup" delay behaviors available in the IGPs. http://www.cisco.com/en/US/products/ps6550/products_white_paper09186a008016317c.shtml The "bgp update-delay n" command may be entered on the Cisco NSF-capable router. The update-delay specifies the time interval- after the first peer has reconnected during which the restarting router expects to receive all BGP updates and the EOR marker from all of its configured peers. The default value of n is 120 seconds, and n is always measured in seconds. If the restarting router has a large number of peers, each with a large number of updates to be sent, this value may need to be increased from its default value. -- Richard A Steenbergen <r...@e-gerbil.net> http://www.e-gerbil.net/ras GPG Key ID: 0xF8B12CBC (7535 7F59 8204 ED1F CC1C 53AF 4C41 5ECA F8B1 2CBC) _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/