I seem to remember CatOS 7.x and above needing a ROMMON version of 6.x or above. I don't think your 5.4(1) will do it. It's a downloadable upgrade.
Chuck -----Original Message----- From: cisco-nsp-boun...@puck.nether.net [mailto:cisco-nsp-boun...@puck.nether.net] On Behalf Of Sony Scaria Sent: Saturday, December 05, 2009 7:37 AM To: cisco-nsp@puck.nether.net Subject: [Suspected Spam][c-nsp] Rmon checksum failed on WS-C4006 Hi All, I've observed "Rmon checksum failed" when I run sh ver on one of my catos switch. The system is stable for a long time and I did not observe any related logs. I had done some research , but couldn't gather any info on "Rmon checksum". cat4013 > (enable) sh ver WS-C4006 Software, Version NmpSW: 8.4(5)GLX Copyright (c) 1995-2005 by Cisco Systems, Inc. NMP S/W compiled on Jan 12 2005, 12:30:16 GSP S/W compiled on Jan 12 2005, 11:47:47 System Bootstrap Version: 5.4(1) Hardware Version: 3.2 Model: WS-C4006 Serial #: FOXXXXXXX Mod Port Model Serial # Versions --- ---- ------------------ -------------------- --------------------------------- 1 2 WS-X4013 JABXXXXXXXX Hw : 3.2 Gsp: 8.4(5.0) Nmp: 8.4(5)GLX 2 48 WS-X4148-RJ JABXXXXXXX Hw : 3.0 3 48 WS-X4148-RJ JABXXXXXXX Hw : 3.0 4 48 WS-X4148-RJ JABXXXXXXX Hw : 3.0 5 48 WS-X4148-RJ JABXXXXXXX Hw : 3.0 6 48 WS-X4148-RJ JAEXXXXXXX Hw : 2.3 DRAM FLASH NVRAM Module Total Used Free Total Used Free Total Used Free ------ ------- ------- ------- ------- ------- ------- ----- ----- ----- 1 65536K 40542K 24994K 16384K 5760K 10624K 480K 402K 78K Rmon checksum failed. Uptime is 323 days, 10 hours, 34 minutes ---------------------------------------------------------------------------- ------------------------------- cat4013> (enable) sh test Diagnostic mode (mode at next reset:) complete Environmental Status (. = Pass, F = Fail, U = Unknown, N = Not Present) PS1: . PS2: . PS3: . PS1 Fan: . PS2 Fan: . PS3 Fan: . PEM: N Fan Tray: . Temperature: . Chassis Temperature: 43 degC (110 degF) Over Temperature Threshold: 75 degC (167 degF) Critical Temperature Threshold: 95 degC (203 degF) Module 1 : 2-port 1000BaseX Supervisor POST Results Network Management Processor (NMP) Status: (. = Pass, F = Fail, U = Unknown) Galaxy Supervisor Status : . CPU Components Status Processor : . DRAM : . RTC : . EEPROM : . FLASH : . NVRAM : . Temperature Sensor : . Uplink Port 1 : . Uplink Port 2 : . Me1 Status : . EOBC Status : . SCX1000 - 0 Register : . Switch Sram : . Switch Gigaports 0: . 1: . 2: . 3: . 4: . 5: . 6: . 7: . 8: . 9: . 10: . 11: . SCX1000 - 1 Register : . Switch Sram : . Switch Gigaports 0: . 1: . 2: . 3: . 4: . 5: . 6: . 7: . 8: . 9: . 10: . 11: . SCX1000 - 2 Register : . Switch Sram : . Switch Gigaports 0: . 1: . 2: . 3: . 4: . 5: . 6: . 7: . 8: . 9: . 10: . 11: . GBIC Status: (. = Pass, F = Fail, N = No Gbic, X = Non-Gbic Port) Ports 1 2 ------ . . cat4013> (enable) Sony. _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/