This sounds like CSCsu69951 which is an internal bug, so won't be viewable on CCO.

Details of same:

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

Symptom  and  Conditions:
-------------------------

On any interface if " xconnect <ipaddress> < VC id > encapsulation mpls " command is configured, then " sw / no sw " conversion are not allowed. But if the " xconnect ..." command is removed, " sw / no sw " command should be allowed.

But the issue is even after removing the " xconnect ... " command the " sw / no sw " commands are rejected.


Workaround:
-----------

Reload the box, after removing the command " xconnect <IP - addr> <VC > encap mpls "from the interface.


+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

I see the fix in SXI train. It went in 12.2(33)SXI01

I don't see a fix in SXH train. Would be good to open a TAC case, so they can verify above and get it in SXH train.


Hope that helps.

Shimol



On 4/8/10 8:24 AM, Gert Doering wrote:
Hi,

I'm not sure if you have seen this beauty...

Labbing SXH7 before upgrading production machines, I configured a port
from its default state on the lab box (switchport) to "test EoMPLS here",
and after the test was done, I wanted to configure the port back.

- "default interface gi5/2", then "put switchport config back in".

... and this is what I get:

Cisco-M-LAB(config)#int g5/2
Cisco-M-LAB(config-if)#swi
GigabitEthernet5/2: Port mode modified in another CLI session, ignoring [no] 
switchport cmd
Cisco-M-LAB(config-if)#^Z

Cisco-M-LAB#who
     Line       User       Host(s)              Idle       Location
*  1 vty 0     gert       idle                 00:00:00 195.30.x.x

   Interface      User        Mode                     Idle     Peer Address

Cisco-M-LAB#sh run int g5/2
Building configuration...

Current configuration : 51 bytes
!
interface GigabitEthernet5/2
  no ip address
end

... there's exactly *me* on this router, nobody else is logged in,
but it's still refusing to cooperate...

*sigh*

I don't think I can bear opening a TAC case for this, I think I will just
go somewhere and laugh manically for a few minutes...

gert




_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

Reply via email to