All,
We have three E1 voice circuits on a 2821 - two from the same provider
on on E1 0/0/0 and E1 0/0/1, and a third from a different provider on a
E1 0/1/0 - a separate VIC.
After fixing a broken fan on the router, the third E1 is experiencing
slip seconds. The other two are clean, and I suspect this is due to the
router being configure to use the clock from E1 0/0/0. There is no loss
of service, however I'm keen to sort out this problem as it might affect
service in the future.
How can I resolve the problem? Is it possible to use a different clock
for each VIC?
Regards,
Peter
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/