Perhaps you have way too much ongoing translations. You can surpass the problems if you try to tweak the NAT settings a bit. Try to play with the "ip nat translation timeout" settings, there are absolute timeouts or protocol based timeouts. You can also limit the total amount of translations performed, also globally or protocol based A combination of both may bring you to the optimal settings for you. Check your "sh ip nat statistics" output for hints on what's causing the exhaust. HTH Ziv
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Mohammad Khalil Sent: Sunday, September 26, 2010 3:48 PM To: [email protected] Subject: [c-nsp] NAT issue Hi all i have configured NAT on Cisco 2811 sometimes we face disconnections and the problem is resolved after clearing the NAT translations is that logic ? what is the best way to monitor the NAT translations ? Thanks _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ ************************************************************************************ This footnote confirms that this email message has been scanned by PineApp Mail-SeCure for the presence of malicious code, vandals & computer viruses. ************************************************************************************ ************************************************************************************ This footnote confirms that this email message has been scanned by PineApp Mail-SeCure for the presence of malicious code, vandals & computer viruses. ************************************************************************************ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
