M K wrote:
Hi all, i have the below OER question i have been trying since a while but i am not sure about the solution can anyone please help ? Configure R4 to be the master controller and R1 and R2 to be the Border routers. The OER implementation should be optimized such that when the packets with a DSCP of 41 is passing through the network, it is routed out to R1 exit interface and also, when a DSCP of 31 is passing through, it is routed out to R2 exit interface. You are allowed to create extended ACL with one entry to accomplish this task. Set active probes only For traffic going from Vlan 44 to YY.YY.55.5, set jitter as 40, delay as 20, probe frequency as 2. Enable constant probe via all exit interfaces. R5 -- SW2 -- SW1 -- R1 F0/0 R1 S0/0 -- R4 S0/0 , R4 S0/1 -- R2 S0/0 R2 F0/0 -- SW4 -- SW3 all the switches are trunk interconnected
The wording on this question sounds suspiciously like a Cisco certification question and that you are fishing for an answer.
-- ========= bep _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/