Just adding to my last questions about hp and FCOE Has anyone seen anything like this?
Can only get maximum 2 fabric logins per fabric from FCOE devices using Emulex 554 CNAs (have 4 servers/8 CNAs) Results from starting each server in order, 30 secs apart: Boot server 1 only – both CNAs login (see inside the CAN bios) Boot server 2 next – only 1 CNA will login (again can see on BIOS) Boot server 3 – sometimes 1 will login, though mostly none will Boot server 4 – no CNAs log in. Shutdown and boot each server in any order, the configurations above stay the same. If I reset the B22 fabric extended, and do a hard reset of each blade server and do the following in order, leaving 30 seconds apart: Boot server 4 only – both CNAs login (see inside the CAN bios) Boot server 2 next – only 1 CNA will login (again can see on BIOS) Boot server 1 – sometimes 1 will login, though mostly none will Boot server 3 – no CNAs log in. Repeat the above procedure in a different order and the first server to start always gets 2 CNAs to login, the next gets 1 CAN to login and so forth. Emulex 554 bios is at v 4.1.402.20 Currently have a tac case open to look at this at it ring to be a licensing issue on the 5596 for FCOE but from what I can see it looks like we are licensed for it. _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/