hi,everybody: I have add two line command for my FWSW PAT configure. nat (inside) 100 129.1.1.0 255.255.255.0 global (outside) 100 122.226.204.41
but,now i can't remove this command from FWSW running-configure. FWSM(config)# no nat (in FWSM(config)# no nat (inside) ? configure mode commands/options: <0-2147483647> The <nat_id> of this group of hosts/networks. This <nat_id> will be referenced by the global command to associate a global pool with the local IP address. <nat_id> '0' is used to indicate no address translation for local IP. The limit is 65535 with access-lists FWSM(config)# no nat (inside) 100 ? configure mode commands/options: access-list Specify access-list name after this keyword FWSM(config)# no nat (inside) 100 ERROR: % Incomplete command JH-DYGS-FWSM(config)# no nat (inside) 100 ? configure mode commands/options: access-list Specify access-list name after this keyword FWSM(config)# FWSM(config)# show version FWSM Firewall Version 3.2(8) Detected an old ASDM version. You will need to upgrade it before using ASDM. Compiled on Fri 29-Aug-08 15:09 by fwsmbld JH-DYGS-FWSM up 1 year 142 days Hardware: WS-SVC-FWM-1, 1024 MB RAM, CPU Pentium III 1000 MHz Flash SMART CF @ 0xc321, 20MB another question: nat (inside) 18 0.0.0.0 0.0.0.0 if this commmand match any real inside network traffic? _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/