Hi all,
I have a simple test setup where I'm most likely failing to do something
right.
It basically looks like this:
My PC --- CPE --- L3 transport network not under my control -- their
router (MSDP + BGP + RP here) ---- ( MSDP+ BGP + RP here) C4900
(192.168.1.1) -- (192.168.1.2) - multicast source (S)
I announce (and originate on the C4900) through BGP the multicast
sources subnet let's call it: 10.10.10.0/29 which I send to my provider
(along with the RP/MSDP IP).
MSDP peers are up, everything seems ok.
a) if I put the 10.10.10.0/29 class as directly connected (between C4900
and S) instead of the 192.168.1.1 and 192.168.1.2 from above -> all
works ok and I can view the stream on my PC with VLC.
I also see:
(10.10.10.1, 233.224.26.1), 00:00:09/00:02:58, flags: PTA
Incoming interface: GigabitEthernet1/48, RPF nbr 0.0.0.0
Outgoing interface list: Null
b) if I put:
10.10.10.1/29 or /32 configured on S on a Loopback interface
and on C4900:
ip route 10.10.10.0 255.255.255.240 192.168.1.2
then I only have:
(10.10.10.1, 233.224.26.1), 00:00:05/00:02:57, flags: PT
Incoming interface: GigabitEthernet1/48, RPF nbr 192.168.1.2
Outgoing interface list: Null
the A flag - MSDP Adv candidate is missing
and if I do a: show ip msdp peer <peer ip> advertise-sa, then I see nothing.
What am I missing ?
Am I running into any check that I am failing ?
Can you help me out ?
This subject is quite new to me.
Thanks,
Mihai
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
