We have two WiSM2 modules in redundant setup where one module has all the licences and the other one is in hot standby state. Both modules run the software 7.4.100. We have seen the following annoying behaviour when we have tested the redundancy. I have no reason to believe that the same wouldn't happen if one of the modules failed for real.
When the hot standby module becomes the active one and all the access points are connected to it suddenly all the WPA protected SSIDs become unusable for most of the clients. The reason is that networks are advertised as ad-hoc ones and not as infrastructure ones. When the networks are disabled and enabled from the WiSM2 they continue operating normally. Has anyone else seen this problem? Does anyone know any solution or is it a new or even a known bug yet to be fixed? Cheers, Matti _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/