Hello Experts, I'm trying to configure the same link local adddress (fe80::1) as glbp address at all SVIs, but the switch (Sup2T with 15.1(1)SY1) refuse this:
#sh run int vl 1 Building configuration... Current configuration : 100 bytes ! interface Vlan1 no ip address glbp 0 ipv6 FE80::1 shutdown ipv6 address 2001:DB8:1::1/64 end #sh run int vl 2 Building configuration... Current configuration : 79 bytes ! interface Vlan2 no ip address shutdown ipv6 address 2001:DB8:2::1/64 end #conf t Enter configuration commands, one per line. End with CNTL/Z. (config)#interface Vlan2 (config-if)#glbp 0 ipv6 FE80::1 % Address FE80::1 in group 0 - interface Vlan1 (config-if)# (config-if)#glbp 2 ipv6 FE80::1 % Address FE80::1 in group 0 - interface Vlan1 (config-if)# Why? What kind of limitation causes this behavior? Regards Friedemann _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/