Great, thanks so much.
1) Was the dynamic allocation of buffers to the queues/classes that needed them always there, even in 12.2x code releases? 2) Could you oversubscribe the 18Mbytes in code prior to any 15.x release? I do not recall reading anything in the release notes about a change in the behavior such as this so I assume it was always there. (Sorry if I missed something in the docs.) So, perhaps the only limiting factor to how much burst or maximum throughput a port could handle had to do with the 491520 Bytes (pre-15.24S) per queue max. (If you couldn't oversubscribe the 18MB, then that would come out to a max of ~38 queues that could be maxed out to 491520 bytes). 3) I see now how the availability of the queue percent feature allows the ability of a queue to use more than the old (old = 15.2(4)S) max of 2Mbytes provided the resources are available. Not a question, just a comment. And a sigh of relief. -Julie Julie Rudolph From: Waris Sagheer (waris) [mailto:wa...@cisco.com] Sent: Thursday, December 26, 2013 3:38 PM To: Julie Rudolph; cisco-nsp@puck.nether.net Subject: Re: [c-nsp] ME3600x buffer calculations- revisited Hi Julie, Replies inline [Waris] From: Julie Rudolph <julie.rudo...@cdw.com<mailto:julie.rudo...@cdw.com>> Date: Tuesday, December 24, 2013 4:17 PM To: "cisco-nsp@puck.nether.net<mailto:cisco-nsp@puck.nether.net>" <cisco-nsp@puck.nether.net<mailto:cisco-nsp@puck.nether.net>> Subject: [c-nsp] ME3600x buffer calculations- revisited Hello: My questions key off of this thread: http://www.gossamer-threads.com/lists/cisco/nsp/172513. I just seek a bit more clarification. Wondering if anyone knows the answers to the following 2 questions: 1) When using queue-limit percent, does this mean the switch will take that as a percentage of the 18MB of packet buffer for the ASIC serving the Gig ports on the switch? Moreover, does it mean that the switch will dynamically allocate buffers to where they are needed, with the switch allocating the associated buffers to the busy interfaces (but not above the percentage of buffer that was specificied for that class(es) in question? [Waris] That's correct. There is no per port buffers. Buffer allocation is done dynamically by an intelligent allocator based on the interface requirement and configuration. 2) If I have 20 interfaces on the same asic (the one with 18MB available buffer) with QOS classes that each have the max of 2Mbytes specified as the queue-limit and those limits exceed 18MB, what will happen? [Waris] Configuration oversubscription is supported since we assume not all the queues are oversubscribed at the same time. 3) Lastly, has anyone ever had to configure queue-limits on the TenGig interfaces (i.e the default queue-limits weren't enough)? [Waris] I have seen many providers who have changed the default queue-limit on 10Gig. Thanks, Julie _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net<mailto:cisco-nsp@puck.nether.net> https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
