Hi, we have a Stone Age router running here that wastes about 14HU of space that I need for something else: 12008/GRP 2x 1GBit NICs (upstream) One ATM card: NAME: "slot 2", DESCR: "4 port ATM OC3 single mode, HwVer#: 1.1, SwVer#: 0.0" PID: 800-3873-01 rev K0 dev 994423, VID: V00, SN:
We use only one of the 4 ports to terminate 6 old SDSL lines. Config: interface ATM2/3 no ip address no ip directed-broadcast atm sonet stm-1 no atm enable-ilmi-trap no atm auto-configuration no atm ilmi-keepalive no atm address-registration no atm ilmi-enable 6x Subinterface: interface ATM2/3.xxx point-to-point ip unnumbered Loopback1 no ip directed-broadcast no atm enable-ilmi-trap pvc 3/xxx oam-pvc manage encapsulation aal5snap ip route x.x.x.x 255.255.255.248 ATM2/3.104 interface Loopback1 description DSL-Loopback ip address no ip directed-broadcast end Traffic is less than 10 MBit, uses IPv4 only and receives a few routes via OSPF. I would like to replace that box with something that is much smaller and consumes less power. I have no clue about non-ethernet technology like ATM and so on and also no possibility for playing around/testing with another line. Can you recommend something that I can use as a small (1 or 2 HU) + cheap 1:1 replacement? kind regards Rolf Hanßen _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/