Also please post the show mroute. This is kind of blind troubleshooting...
On Wed, Jan 28, 2015 at 10:14 AM, Scott Voll <svoll.v...@gmail.com> wrote: > and, remember that VLC only has a TTL of one I think..... so in your VLC > config change your TTL to something like 10 (depending on the size of the > whole network). > > Scott > > > On Wed, Jan 28, 2015 at 9:55 AM, Antonio Soares <amsoa...@netcabo.pt> wrote: > >> Enable PIM on the loopback. >> >> >> Regards, >> >> Antonio Soares, CCIE #18473 (RS/SP) >> amsoa...@netcabo.pt >> http://www.ccie18473.net >> >> -----Original Message----- >> From: cisco-nsp [mailto:cisco-nsp-boun...@puck.nether.net] On Behalf Of >> Lobo >> Sent: quarta-feira, 28 de Janeiro de 2015 17:38 >> To: cisco-nsp@puck.nether.net >> Subject: [c-nsp] Enabling multicast routing on 3750G platform >> >> Hi everyone. I've been trying to get multicast routing to work on a single >> 3750G switch between two vlans but for the life of me it just doesn't work. >> When the host and receiver are on a single vlan the streaming works but >> then >> you don't even need multicast routing enabled for it to work. >> When I split the two hosts onto separate vlans that's where the problem >> begins. >> >> This is what I've configured so far and I'm sure it's just some extra >> commands I'm missing or something: >> >> ip multicast-routing distributed >> ! >> ip pim rp-address 3.3.3.3 >> ! >> interface Loopback0 >> ip address 3.3.3.3 255.255.255.255 >> ! >> interface GigabitEthernet1/0/1 >> switchport access vlan 100 >> ! >> interface GigabitEthernet1/0/2 >> switchport access vlan 200 >> ! >> interface Vlan100 >> ip address 1.1.1.2 255.255.255.0 >> ip pim sparse-dense-mode >> ! >> interface Vlan200 >> ip address 2.2.2.2 255.255.255.0 >> ip pim sparse-dense-mode >> ip igmp join-group 239.0.0.1 >> ! >> >> The server streaming via VLC is 1.1.1.1 and is using 239.0.0.1 for the >> multicast address. The receiver is 2.2.2.1 and using VLC to stream. I can >> see the traffic coming in on port 1 but no traffic leaving the switch's >> other port. >> >> BTW, I tried dense-mode and sparse-mode as well with similar results. >> >> Any thoughts? >> >> Jose >> _______________________________________________ >> cisco-nsp mailing list cisco-nsp@puck.nether.net >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ >> >> _______________________________________________ >> cisco-nsp mailing list cisco-nsp@puck.nether.net >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ >> > _______________________________________________ > cisco-nsp mailing list cisco-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/