Hi All, First thanks to everyone.
WE have a port channel on NX 5548 connected to Cisco FI. There are two 10Gb interface are bounded to it. Here when we checked the sh int portchannel 1. it shows following output. port-channel1 is up Hardware: Port-Channel, address: 002a.6a4d.0f68 (bia 002a.6a4d.0f68) MTU 1500 bytes, BW 20000000 Kbit, DLY 10 usec reliability 255/255, txload 5/255, rxload 13/255 Encapsulation ARPA Port mode is trunk full-duplex, 10 Gb/s Input flow-control is off, output flow-control is off Switchport monitor is off EtherType is 0x8100 Members in this channel: Eth1/1, Eth1/2 1 interface resets 30 seconds input rate 611861136 bits/sec, 64564 packets/sec 30 seconds output rate 403292840 bits/sec, 45537 packets/sec Would like to know the two different speeds shows in the output. I,e 20Gb and 10Gb -- With Regards, Sathish Ippani 9177166040 _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/