Usually, both ends of a SAToP circuits will be "TDM". You can map timeslots across ports, but your ds3 SAToP endpoint would have to be looped back to a service ds3 interface...
Arie On Wed, Jun 17, 2015, 07:58 Mike <[email protected]> wrote: > Hello, > > I'm trying to determine if there is a way to cut some equipment and > complexity out of my network. > > I have T1 loops connecting to an aggregation device, which packages > these up into satop frames for transport across my network. On the > receiving end, another device demuxes satop, then creates a channelized > ds3 with the aggregated loops. This channelized ds3 then connects to a > cisco router, which then provides PPP over individual serial interfaces > represented by the chan-ds3. The application here is strictly internet > access and I don't see any need for the clocking or other features of > 't1' - it's just being used to transport PPP frames. It seems to me > that it should be possible to not have the demux/remux/ds3 part of this. > I am wondering if there is any built in cisco functionality for directly > terminating an SAToP stream into a 'circuit' that then has PPP? > > Mike- > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
