On Mon, 2019-02-18 at 20:14 +0000, Tom Hill wrote: > On 14/02/2019 09:01, Christophe Fillot wrote: > > Anyone knows if this platform supports QinQ termination ? > > > > The "encapsulation dot1q X second-dot1q Y" command is not present, > > but > > maybe there is another way to do it ? > > EVCs?
I don't think it does double tagging even with EVCs. The following is from a Sup6T running 15.3, but I think 15.5 is the same. I would love to hear that it isn't, I don't have a 15.5 box to test right now. Router(config)#spanning-tree mode mst Router(config)#dot1ad Router(config)#default interface Te3/7 Interface TenGigabitEthernet3/7 set to default configuration Router(config)#do show run interface Te3/7 Building configuration... Current configuration : 190 bytes ! interface TenGigabitEthernet3/7 no ip address end Router(config)#interface TenGigabitEthernet3/7 Router(config-if)#switchport Router(config-if)#switchport mode trunk Router(config-if)#switchport nonegotiate Router(config-if)#dot1ad uni Router(config-if)#service instance 1 ethernet Router(config-if-srv)#encapsulation dot1q ? <1-4094> VLAN id any For all VLANS [1-4094] Router(config-if-srv)#encapsulation dot1q 200 ? , comma - hyphen cos cos Vlan <cr> Router(config-if-srv)#do show run interface Te3/7 Building configuration... Current configuration : 190 bytes ! interface TenGigabitEthernet3/7 switchport switchport mode trunk switchport nonegotiate dot1ad uni no cdp enable spanning-tree bpdufilter enable service instance 1 ethernet ! end -- Peter _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/