If the paging controller is taking the ATA off-hook as soon as you plug it in, then it sounds to me like the interface on the paging controller is the wrong kind of interface (perhaps needs to be configured).
Disconnect supervision issues would show up *after* making an announcement, but you are not even making it that far. -mn From: cisco-voip [mailto:cisco-voip-boun...@puck.nether.net] On Behalf Of Cannizzaro, Vince Sent: July-22-16 11:37 AM To: 'cisco-voip@puck.nether.net' <cisco-voip@puck.nether.net> Subject: [cisco-voip] Supervisory Disconnect on ATA 190 Hi everyone, I'm trying to connect an ATA 190 to a Logison Paging Module a vendor installed to get paging functionality at a site. The vendor has stated the following: "Upon dialing the specific extension assigned to paging, this line is "live" (i.e. answers the line A.K.A. Auto Answer) to complete the connection to the Logison NCP and enables the page to be broadcast on all the Logison Speakers you have assigned to that specific paging zone. The line must also be programmed with Supervisor Disconnect (this ensures that the page is disconnected once the user has stopped talking and hangs up)." As it stands, as soon as I plug in the analog line into the ATA you can hear dial tone over the speakers and then eventually times out. I can't see where to configure supervisory disconnect on an ATA 190. I can't use a router FXS port as the router is in another network closet. Am I missing something? Thank you, Vince
_______________________________________________ cisco-voip mailing list cisco-voip@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-voip