That is exactly what I’m not trying to do. Everytime I mention PLAR or ARD those are the articles I’m referred to and are not helpful. That example and others are for courtesy phones, hotlines, etc..
What I need to do is when a dedicated T1 channel on the voice gateway (IOS 2800) goes off-hook it routes to a DN on the phone. When the same DN is picked up, it dials a number that routes back to the same channel on the voice gateway. I can do this with two buttons (one being a speed dial, and the other being a DN), but I need this to be a single button. Someone could have 20 different ring downs on the same phone device. Matthew Huff | Director of Technical Operations | OTA Management LLC Office: 914-460-4039 mh...@ox.com<mailto:mh...@ox.com> | www.ox.com<http://www.ox.com> ........................................................................................................................................... From: Austin Williams <austinpucknet...@gmail.com> Sent: Friday, October 8, 2021 12:49 PM To: Matthew Huff <mh...@ox.com> Cc: Cisco VoIP Group <cisco-voip@puck.nether.net> Subject: Re: [cisco-voip] Single button ARD What are your gateways built with, MGCP, H323, SIP? What version of call manager are you working on? Ringdowns for call managers are built using CSSs, Partitions and a Null Translation pattern. Here is a good article on it: https://www.networkcomputing.com/networking/using-cucm-configure-plar-phones On Fri, Oct 8, 2021 at 11:19 AM Matthew Huff <mh...@ox.com<mailto:mh...@ox.com>> wrote: I’m trying to setup a button on people’s phone where they will get inbound calls like a (DN) when voice-port goes off-hook on our gateway (connection plar xxxx). When the button is pressed on any phone, it should do the same thing, take the channel off hook on the voice gateway. All the example’s I’ve seen are for doing PLAR when the phone goes offhook or the “new call button” is pressed, but not a separate line. I’ve done this in the past with CME like: voice-port 0/3/1:0 define Tx-bits idle 1111 define Tx-bits seize 0000 define Rx-bits idle 1111 define Rx-bits seize 0000 no vad no comfort-noise connection plar B100 ephone-dn 32 number B100 trunk B101 Matthew Huff | Director of Technical Operations | OTA Management LLC Office: 914-460-4039 mh...@ox.com<mailto:mh...@ox.com> | www.ox.com<http://www.ox.com> ........................................................................................................................................... _______________________________________________ cisco-voip mailing list cisco-voip@puck.nether.net<mailto:cisco-voip@puck.nether.net> https://puck.nether.net/mailman/listinfo/cisco-voip
_______________________________________________ cisco-voip mailing list cisco-voip@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-voip
