I was curious if anyone else had seen this.
We have a 2600 with 2 T1's going to other sights. The
ethernet port connects it to a Bay 450 10/100 switch.
Both switch and router ports are set to 10 / half, but
we're still seeing a collision rate of about 19% This seems
pretty high to me. Anyone have any thoughts?
Here's the port info...
show int e 0/0
Ethernet0/0 is up, line protocol is up
Hardware is AmdP2, address is 0030.1922.5340 (bia 0030.1922.5340)
Internet address is 10.15.28.2/24
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 34/255
Encapsulation ARPA, loopback not set, keepalive not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:49:19
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 2044000 bits/sec, 356 packets/sec
5 minute output rate 1365000 bits/sec, 334 packets/sec
1091341 packets input, 848224944 bytes, 0 no buffer
Received 16001 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 input packets with dribble condition detected
965919 packets output, 314732326 bytes, 0 underruns
0 output errors, 183580 collisions, 0 interface resets
0 babbles, 0 late collision, 69923 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Ed
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
