Hello
I'm having an issue with 7507 not recognizing serial interface created on
pa-mct3 DS-3 card. It creates the interface correctly but when I try to
configure the serial it gives an invalid input marker.
This is config of router:
controller T3 6/0/0
clock source line
cablelength 50
t1 10 channel-group 0 timeslots 1-2
interface Serial6/0/0/10:0
no ip address
no ip directed-broadcast
no ip proxy-arp
no ip route-cache distributed
NASHVILLE-HYP-7507#sh int se6/0/0/10:0
^
% Invalid input detected at '^' marker.
As anyone seen this before? I talked to Cisco TAC and they do not know of
any bugs that would cause this but it is a major problem.
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
