Hey Guys, I need help configuring a motorola V3600. I know that this is not the right place to ask but I have no luck in both comp.dcom.sys.cisco and cisco TAC. Somebody might have seen this problem with solution. Thanks. Anyway, I'm trying to configure a sync motorola v.36 modem using 2520 attached to the a/s port using v.25bis to dial. However, with this configuration, the DCD goes up and this is what it shows when I do sh int s3: LCP REQsent Closed: IPCP DCD=up DSR=down DTR=up RTS=up CTS=up Here's the router config: int s3 ip address 172.16.10.1 255.255.255.0 encap ppp dialer in-band dialer map ip 172.16.10.2 name routerb 5551212 no cdp enable dialer-group 1 on the Motorola V.36 Modem part of the config: V.25 SDLC Dialer ASCII/NRZ DTR disconnects DSR is normal DCD is normal CTS follows RTS DTE fallback disabled ___________________________________ UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html FAQ, list archives, and subscription info: http://www.groupstudy.com Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
