When you use the MSFC mls rp is automatically configured to the MSFC. The
only reason that you would need
to enable it is you had disabled it. Check out this link, watch the wrap.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/ios127xe/config/
mls.htm
or
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_5_3/msfc/mls.
htm
----- Original Message -----
From: "Kent" <[EMAIL PROTECTED]>
To: "Michael Rasmussen" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]>
Sent: Tuesday, June 06, 2000 3:28 PM
Subject: Re: 6506 Vlan and layer 3 switching question
> I understood, you have to configure mls rp for the
> mulitlayer swithing to work, right? why you do not
> need mls rp when using MSFC? Is that because the RSM
> is on board, it automatically does the multilayer
> swithing to the MSFC card?
>
> Thanks
>
> Kent
> --- Michael Rasmussen <tke
> [EMAIL PROTECTED]> wrote:
> > You shouldn't have to do anything else to route
> > between just those two VLANs. Also just a side
> > note. The mls rp ip command is not necessary since
> > you are using the MSFC.
> > ""Josh Youngman"" <[EMAIL PROTECTED]>
> > wrote in message
> >
> 002801bfcf35$caaaa2e0$[EMAIL PROTECTED]">news:002801bfcf35$caaaa2e0$[EMAIL PROTECTED]...
> > i have a 6506 with a 48prt 10/100 blade i wish to
> > configure 6 ports on one subnet (vlan2) and the rest
> > on another (Vlan1) and use the supervisor to route
> > between the two vlans. does anyone have any sample
> > configs on how to do this. so far i have
> > created the two vlans and assigned the ports. i
> > then did a session 15:
> > !
> > router rip
> > network 10.0.0.0
> > !
> > Interface vlan1
> > set ip address 10.0.8.21 255.255.252.0
> > mls rp ip
> > !
> > interface vlan2
> > set ip add 10.0.12.21 255.255.252.0
> > mls rp ip
> > !
> > !
> >
> > what else do i need here to route between the two
> > vlans?
> >
> > thanks for any help.
> >
>
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Photos -- now, 100 FREE prints!
> http://photos.yahoo.com
>
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
