Hi, Anyone have any experiences of configure using AUX port dial to ISP ? I am facing some problem, the line is dialing to ISP but disconnected after 2 seconds. Here is my summary of config file and the debug output. Do I need need the 'logn' script ?? Thanks a lot. chat-script cisco-default ABORT ERROR "" "AT Z" OK "ATDT\T" TIMEOUT 30 \c CONNECT \c interface Async5 ip address negotiated no ip directed-broadcast encapsulation ppp dialer in-band dialer string 9w1511 dialer-group 2 async default routing async mode dedicated fair-queue 64 16 0 ppp authentication pap callin ppp pap sent-username abcdef password 7 123456789 ip classless ip route 0.0.0.0 0.0.0.0 Async5 access-list 10 permit 10.10.10.11 #I only allow these 2 IP addresses to initiate call # access-list 10 permit 10.10.10.90 dialer-list 2 protocol ip list 10 line aux 0 script dialer cisco-default script activation jaring modem InOut modem autoconfigure type usr_sportster transport input all speed 115200 flowcontrol hardware DEBUG OUPUT :: 12:40:24: Async5 DDR: Dialing cause ip (s=10.10.10.90, d=202.187.166.1) 12:40:24: Async5 DDR: Attempting to dial 9w1511 12:40:24: CHAT5: Attempting async line dialer script 12:40:24: CHAT5: Dialing using Modem script: cisco-default & System script: none 12:40:24: CHAT5: process started 12:40:24: CHAT5: Asserting DTR 12:40:24: CHAT5: Chat script cisco-default started..... 12:40:55: CHAT5: Chat script cisco-default finished, status = Connection timed out; remote host not responding 12:40:55: Async5 DDR: disconnecting call Choh Koon, Tan CCDA,CCNP ___________________________________ UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html FAQ, list archives, and subscription info: http://www.groupstudy.com Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
