The said is the following:
The Catalyst 5000 series switch uses the SAID parameter of the set vlan
command to identify each VLAN on an 802.10 trunk. The default
SAID for VLAN 1 is 100001, for VLAN 2 is 100002, for VLAN 3 is 100003, and
so on.
802.10 Protocol on FDDI Ports
VLANs can be extended across an FDDI network by multiplexing switched
packets over a Copper Distributed Data Interface (CDDI)/FDDI
interface using the 802.10 protocol. Using 802.10, Catalyst 5000
CDDI/FDDI interface links can operate as interswitch trunks that
provide broadcast control between configured VLANs. The 802.10
protocol encapsulates a VLAN identifier and packet data according to
the IEEE 802.10 specification. CDDI/FDDI interfaces that support
802.10 make selective forwarding decisions within a network domain
based upon the VLAN identifier.
The VLAN identifier is a user-configurable four-byte SAID. The SAID
identifies traffic as belonging to a particular VLAN. It also
determines which VLAN each packet is switched to the bus.
Hope that answers your question.
Dan
>From: "mahinder" <[EMAIL PROTECTED]>
>Reply-To: "mahinder" <[EMAIL PROTECTED]>
>To: [EMAIL PROTECTED]
>Subject: I have a dumb question
>Date: Thu, 6 Jul 2000 12:51:26 -0700
>
>when you configure a Vlan on a 6000 switch the command goes like this:
>set vlan 500 name Engineering said 100005 mtu 1500
>what does this said stand for ?
>
>Thanks in advance
>
>
>___________________________________
>UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
>FAQ, list archives, and subscription info: http://www.groupstudy.com
>Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]