Variance command is used to load share over unequal paths. i.e. a 1mb and a
2 mb circuit, in normal routing terms the 2mb circuit would be used all the
time (unless specified otherwise). Putting a variance in this case of 2
will allow any the above circuits to load share. Because 1 * 2 = 2.
-----Original Message-----
From: Brandon Carroll [mailto:[EMAIL PROTECTED]]
Sent: 06 July 2000 22:52
To: [EMAIL PROTECTED]
Subject: Varience Question
Hello,
I am in the BSCN class right now and touched on the term "Varience"
Could someone pleas explain this to me. I don't feel it was covered very
well and I am actually feeling a bit lost on this.
Thanks,
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]