Edition By Rob Payne; Kevin Manweiler
If someone is reading this book can they confirm some inconsistencies I've come across while reading the book. I'm currently on Chapter 7 and I've found the following problems (at least I think they are problems) Pg 98. Paragraph Five last sentence reads: "DTE devices include terminals, PCs, routers, and bridges (customer-owned end node and internetworking devices) and DTE devices are devices such as packet switches" Shouldn't it read: "...... and DCE devices are devices such as packet switches" Pg. 193. Figure 6.1 Bit 46 should read U/L and not I/G as listed in bit 47. Pg. 194 Figure 6.2 (Ethernet II Frame) Sync (Pattern 11) should read 2 bits and not "11 bits" Pg. 207 set port duplex 2/10 full is issued in the config but the show port output lists the duplex speed as being half. All the other config changes match up with the output. Pg. 223 (Explanation of the command channel-group 1 mode desirable) Should read PAgP and not DTP. I've come across more , a few matched up with the Errata on Sybex's website. I just haven't been keeping track. I guess I'll start noting mistakes as I find them. If someone can confirm this with me I would appreciate it, and I'm sure the authors would too. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=74091&t=74091 -------------------------------------------------- **Please support GroupStudy by purchasing from the GroupStudy Store: http://shop.groupstudy.com FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
