I don't understand this, wouldn't the client accept the second offer by
sending the seconds servers siaddr in the request packet. also DHCP standard
says that nowhere must a client accept the first offer and then stop
broadcasting. All servers will answer the clients DHCPDISCOVER broadcast
with any help it can or can not offer. The first server does not tell the
second server to shutup so as soon as the (second or 1nanosecond slower
server) receives the broadcast it will it will send a DHCPOFFER packet and
the client will reply with an DHCPREQUEST packet to the second server
(using the siaddr field) that will be ack'd by the second server with an
DHCPACK packet. This is all made quite clear in RFC 1541. So you can have
two DHCP servers on the same segment you just don't know which one will
serve the address to the client but both will try independent of each other
and the client will ot stop trying after receiving after a nack from a
server.
Duck
----- Original Message -----
From: Dale Holmes <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]>
Sent: Friday, September 08, 2000 7:10 AM
Subject: Re: Ip helper address
>
> You have 2 DHCP servers on the same subnet??? This is probably not a good
> idea... it does not really provide redundancy or load balancing.
> The DHCP client will issue a request and accept the first response that it
> gets.
>
> If you split your scope such that half of your available addresses are on
> one server and half are on the other, you will *NOT* see that half of your
> clients use one server while half use the other. If for some reason one
> server always replies a nanosecond earlier than the other, then all
clients
> will accept the response from that server. Once that server is out of
> addresses, it will start sending nack's. The clients will start accepting
> those nack's and will not request an address again, even though the other
> DHCP server may have dozens of free addresses to offer.
>
> SO - in answer to your question, the ip helper address of 10.10.10.0 will
> allow your client's requests to reach all DHCP servers on that subnet,
> HOWEVER they will only accept leases from the first server from which they
> receive a response. Chances are that server will be the same one all the
> time, even after it runs out of addresses to offer...
>
> You *could* set up your DHCP servers such that the scope on EACH ONE is
> sufficient to offer leases to ALL of you clients, but that is probably a
> less than efficient use of your address space.
>
> I hope that this helps...
>
> Dale
> [=`)
>
> >From: "Dennis Bates" <[EMAIL PROTECTED]>
> >Reply-To: "Dennis Bates" <[EMAIL PROTECTED]>
> >To: [EMAIL PROTECTED]
> >Subject: Ip helper address
> >Date: Fri, 8 Sep 2000 08:10:44 -0500
> >
> >I am trying to put a statement on the remote router to allow the clients
to
> >obtain an IP address accross the WAN. I have used the ip helper-address
> >command successfully. My problem is that i would like any of the DHCP
> >servers at the central site to be able to service DHCP requests from the
> >remote site. Do I have to use mutilple ip helper-address statements ? I
> >have tried a helper address pointing to the subnet, but that does not
seem
> >to work. EX. i have DHCP servers at 10.10.10.10 and 10.10.10.11 do i have
> >to
> >use two seperate ip helper address statements or can i use ip
> >helper-address
> >10.10.10.0 ?
> >
> >
> >**NOTE: New CCNA/CCDA List has been formed. For more information go to
> >http://www.groupstudy.com/list/Associate-Announcement.html
> >_________________________________
> >UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> >FAQ, list archives, and subscription info: http://www.groupstudy.com
> >Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
> Share information about yourself, create your own public profile at
> http://profiles.msn.com.
>
> **NOTE: New CCNA/CCDA List has been formed. For more information go to
> http://www.groupstudy.com/list/Associate-Announcement.html
> _________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
