You must reboot after deleting sub interface to completely clear it from
router.
----- Original Message -----
From: "Patrick Stiever" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Wednesday, September 20, 2000 7:58 PM
Subject: Deleting Sub interfaces
> Ladies and Gentlemen,
>
> I have a intresting question, I have a 7204 VXR Router with 12.0(7)T
> IOS. I am using sub-interfaces on the Hssi3/1 interface. When I am no
> longer need a sub-interface I go into config t and type no int
hssi3/1.154.
> It deletes it, but if I type sho int hssi3/1.154 I get the following:
>
> Hssi3/1.154 is deleted, line protocol is down
> Hardware is M2T-HSSI-B
> Description: ............................ Club 095
> MTU 4470 bytes, BW 45045 Kbit, DLY 200 usec,
> reliability 255/255, txload 5/255, rxload 2/255
> Encapsulation FRAME-RELAY
>
>
>
> Is there any way of clearing the information(without rebooting the
> router) so if I type sho int hssi3/1.154 it gives me this:
>
> WComDS3DLCI102#sho int hssi3/1.158
> ^
> % Invalid input detected at '^' marker.
>
>
> Any ideas?????
>
> Thanks
>
> Patrick Stiever
> Communications Engineer
> 24 Hour Fitness
> (760) 918 4459
> [EMAIL PROTECTED]
>
> **NOTE: New CCNA/CCDA List has been formed. For more information go to
> http://www.groupstudy.com/list/Associates.html
> _________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
