what interface PA do you have? Can you post the existing config?
we do the following on our E1s for full (1984k) bandwidth (on 2600s so
syntax may vary for 7200s):
controller E1 1/0
framing NO-CRC4
channel-group 0 timeslots 1-31
this produces a virtual serial as per below:
interface Serial1/0:0
which you configure up with addresses and stuff as for a physical interface.
hth
Andy
----- Original Message -----
From: <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, September 22, 2000 9:02 PM
Subject: time slots
> Hi team....I would rather ask a stupid question and get yeld at by you
guys than do a stupid thing and get fired at my job....
>
> Now, how do I change the time slot on my 7200 router from 256k to full
bandwidth....thanks for your input.
>
> **NOTE: New CCNA/CCDA List has been formed. For more information go to
> http://www.groupstudy.com/list/Associates.html
> _________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
