I am looking for information on taking a RIP, Static Route, BGP
backbone, to EIGRP instead of Rip between access nodes All Routers are
Cisco, some 1601, 3640, 3620, 2610, 7507
I am concerned that when I turn EIGRP on, that it will auto redistribute
the RIP, probably causing a loop or two. Since this is a production net
with about 10 access nodes and 5 backbone nodes I cannot afford to be
down while I troubleshoot each loop.
(R1) ----- (Core 7507)
(R2) ----- (Core 7507)
(R3) ----- (Core1 3640) ----- (Core 7507)
(R4) ----- (Core1 3640) ----- (Core 7507)
All run RIP v2 and/or Static routes with passive interfaces on some of
client side routers.
I have looked at Cisco's website and other sites on the internet as well
as my books.
I am still not finding the "HOW to change routing protocols RIP to EIGRP
while avoiding problems" list of steps. Although I didn't find what I
was looking for I did find many pages on EIGRP on syntax, protocol
specifics, etc... which have not answered my questions yet.
If any of you on the list have done this before and have some references
that you could send to me I would really appreciate it.
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
