If you are routing you are not concerned with stp or if you are bridging
then it will shut down the loop no matter when you activate the interface
Duck
----- Original Message -----
From: Jon Mitchell <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, September 29, 2000 6:02 AM
Subject: STP question
>
> Does STP only stop loops when the router boots? If I am building a loop
> network, and then I boot up the final router with only one interface
> plugged in (so it is not yet a loop), and then plug in the other interface
> after the fact, what will happen? Will the other interface start in
> blocking or forwarding mode? The book I am using does not seem clear on
> this.
>
> --
> Jon Mitchell
> Systems Engineer, Subject Wills & Company
> [EMAIL PROTECTED]
>
> **NOTE: New CCNA/CCDA List has been formed. For more information go to
> http://www.groupstudy.com/list/Associates.html
> _________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
