In a message dated 10/2/00 12:04:33 AM Eastern Daylight Time,
[EMAIL PROTECTED] writes:
<< Does anyone know how to configure Subinterfaces in Frame-Relay between 2
Cisco 2500 Routers? A short example will do...
>>
If you meant to create one then here you go...quite simple actually:
conf t
int s0.x
you will then be in that interface configuration: Router(config-subif)#
All you need to do to create one, for lets say serial 0, is run the interface
command with serial 0.whatever you want the subinterface # to be...for
example... interface s0.1
Hope this was what you were looking for...
Mark Zabludovsky ~ CCNA, CCDA, 1/4-NP
<A HREF="mailto: [EMAIL PROTECTED]">[EMAIL PROTECTED]</A>
"If you need luck, apparently you're not prepared...Go study!"
~Mark Zabludovsky~
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
