Hello Andre,
Ask your DSL provide which VPI/VCI they use and set the 675's VPI/VCI to
that value. If the 675 can sync up then check the downstream and upstream
bit rate upon modem sync up.
Howard Choi
CCNP+ATM, CCDP
----------
From: Andre Fecteau
To: [EMAIL PROTECTED]
Subject: Cisco 675 ADSL
Date: Monday, October 16, 2000 2:46PM
Hello,
Which of these do I have to have configured for my DSL to work? I need
to know what information (parameters) to ask my DSL provider for. This
is a Cisco 675 ADSL router.
SET INTERFACE WANx requires one of the following arguments
base Set the combined VPI/VCI base value
baud Set ADSL baud rate
count Set the VPI count
doh Set the interface to act in Digital Off Hook Mode
maxvcs Set the maximum number of virtual connections
rate up Set upstream ADSL line rate
rate down Set downstream ADSL line rate
rate down:baud Set downstream line rate and baud rate
rate auto Set auto-negotiation mode for this device
txpower Set transmit power
remote txpower Set remote side transmit power
margin Set margin
remote margin Set remote margin
intrleve Set Reed Solomon interleave depth
bitfield Set bitfield parameter
retrain Retrain the ADSL line
up Enable ADSL line
down Disable ADSL line
scramble Cell Scrambling
stay Set stay-trained mode; ADSL line will not re-train
Thank You,
Andre
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
