OT : HP Openview to monitor router and switch

[Benny Leong (HTHK - Senior Engineer II - iServices Development, NNSD)]

Harald,

My Openview is version 6.1.1. From the readme file, this trapd.41x is
required on Openview 4.1 only.

        ----------
        From:  Harald Volz [SMTP:[EMAIL PROTECTED]]
        Sent:  Tuesday, October 17, 2000 9:28 PM
        To:  [EMAIL PROTECTED]
        Subject:  Re: OT : HP Openview to monitor router and switch

        HI you need to include this file into your HP-OV system (follow
instructions inside the
        file)

        ftp://ftpeng.cisco.com/pub/mibs/contrib/trapd.41x

        regards,
        harald

        "Benny Leong (HTHK - Senior Engineer II - iServices Development,
NNSD)" schrieb:

        > I need to monitor Cisco router 7206 and Catalyst 5509 using HP
Openview
        > network management station.  I have loaded the
CISCO-GENERAL-TRAPS.my,
        > however, the station cannot interpret the trap generated by the
routers.
        > What goes wrong ?
        >
        > _________________________________
        > FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
        > Report misconduct and Nondisclosure violations to
[EMAIL PROTECTED]

        _________________________________
        FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
        Report misconduct and Nondisclosure violations to
[EMAIL PROTECTED]

_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]