this is not a RAS problem, it just a modem problem. take its settings to
answer at first ring.. its at command is ATS0=1
good luck
p.s
for easy installation for RAS side use Cisco ConfigMaker. it is free and
downloadable at Cisco site.
-----Original Message-----
From: Sim, CT (Chee Tong) [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, October 18, 2000 1:25 PM
To: 'ElephantChild'; 'FAISAL ATHAR'; '[EMAIL PROTECTED]';
'[EMAIL PROTECTED]'
Subject: access server can't access the dial in- pls help :(
Dear all,
I have configured a access server as shown below, I attach my modem in Asyn
1 port and I can reverse telnet to it and the phone line got no problem.
Besides, I used use a PC (win95) with a modem installed. In win95, I use
hyperterminal to connect the PC modem and tested the at command,.. it work,
so I used atdt 77777 (my access server phone no) but I only heard the ring
ring tone, the access server never accept it but I can see from the word
RING RING on the access server's modem at command console. What should I
configure to let the access server modem pick up the call
############################################################################
#######
interface Ethernet0
ip address 60.200.166.11 255.255.252.0
no logging event subif-link-status
!
interface Async1
ip unnumbered Ethernet0
encapsulation ppp
no logging event subif-link-status
async dynamic address
async mode interactive
peer default ip address 60.200.166.15
!
ip classless
ip route 0.0.0.0 0.0.0.0 60.200.164.1 permanent
!
line con 0
line 1
password abc123
autoselect ppp
login
modem InOut
transport input all
stopbits 1
speed 2400
flowcontrol hardware
==================================================================
De informatie opgenomen in dit bericht kan vertrouwelijk zijn en
is uitsluitend bestemd voor de geadresseerde. Indien u dit bericht
onterecht ontvangt wordt u verzocht de inhoud niet te gebruiken en
de afzender direct te informeren door het bericht te retourneren.
==================================================================
The information contained in this message may be confidential
and is intended to be exclusively for the addressee. Should you
receive this message unintentionally, please do not use the contents
herein and notify the sender immediately by return e-mail.
==================================================================
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
