no,
only if you are config the E1, E1 will use the R2 signalling
also the cas-group is the 12.0 version and the new one is the ds0-group ....
these cas-group and ds0-group is for the IDAM line(24 incoming line or 24
outgoing only), I
or IDAP(23 lines, can configure in or out on each individual line)
Sam
----- Original Message -----
From: cslx <[EMAIL PROTECTED]>
Newsgroups: groupstudy.cisco
To: <[EMAIL PROTECTED]>
Sent: Sunday, October 22, 2000 7:42 PM
Subject: how to setup the channelized E1 of 3640?
> cisco.com only tell me "R2 signaling for CISCO3640",is it means that I
must
> use r2 signaling?is there a default setup? and who can tell me what are
the
> means of "cas-grou"&"cas-custom"?
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
