You can change the sampling time using the 'load-interval [interval]'
command. That will give you anything from 30 seconds to 10 minutes in 30
second increments.
>
>Is there a way to get the average utilization on an interface (serial) for
>more than the default 5 minute period shown by show interfaces? Perhaps if
>there was a setting to increase the time period used, or a command that
>would keep a running tally or even a way to record the utilization in the
>syslog every so often. Any ideas on how to do this without resorting to
>using a third party application?
>
>Thanks.
>
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
Share information about yourself, create your own public profile at
http://profiles.msn.com.
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
